![]() ![]() Add this line last in the file: hass ALL=NOPASSWD:/usr/sbin/pm-suspend, where you replace hass with the name of your user on the target, if different, and /usr/sbin/pm-suspend with the command of your choice, if different. On the target, using an account with sudo access (typically your main account), sudo visudo.On my system, this is /usr/sbin/pm-suspend. First, get the full path: which pm-suspend. Here is it pm-suspend, use poweroff to turn off the computer. On the target, we need to let the hass user execute the program needed to suspend/shut down the target computer.On the server, verify that you can reach your target machine without password by ssh TARGET.Enter the password you created in step 3. On the server, transfer your public SSH key by ssh-copy-id where TARGET is your target machine’s name or IP address.If you do, you can leave out in the SSH commands below. It’s recommended using the same user name as on the server. Just press enter on all questions except password. On the target, create a new account that Home Assistant can ssh into: sudo adduser hass.On the server, create SSH keys by running ssh-keygen.On the server, log in as the user account Home Assistant is running under.Suggested recipe for letting the turn_off script suspend a Linux computer (the target)įrom Home Assistant running on another Linux computer (the server). Here are some real-life examples of how to use the turn_off variable. powercfg.The port to send the magic packet to. Type or paste this command and click on “ OK“. On your host PC, press the Windows key Type: power Select Power options Enable WOL in Windows. You can disable the fast startup so the network devices receive power even when the computer is switched off.ġ.At first, you need to press the Windows key along with the R key together to open the Run window.Ģ. Then, reboot the system Fix – 9 Disable the Fast startup Finally, click on “ OK” to save the setting. Name this new value as “ AllowWakeFromS5“.ĥ. Then, right-click on the left-hand side, right-click on the “ New>” and click on “ DWORD (32-bit) Value“.Ĥ. Usually, it is located in this location – Computer\HKEY_LOCAL_MACHINE\SYSTEM\ControlSet001\Control\Class\\00020202ģ. Then, go to the location where you have found the ‘ S5WakeOnLAN‘ key on your computer. If the previous registry tweak doesn’t work out for you, try these steps.Ģ. After that, shut down your system and try to use the WOL command to wake it up again. Then click on “ Export” to make a new backup on your computer. So, before operating in the registry, you must create a backup of the registry.Īfter opening the Registry Editor, click on “ File“. Registry Editor is one of the most sensitive locations on your computer. In the Run panel, write down “ regedit” and click on “ OK“. You have to edit the registry manually to allow the WOL request to switch ON your computer.ġ. Either you have to put the remote setup in Sleep mode (S3) or you have to disable the fast startup so that WOL can work properly. The actual reason behind this is because Windows 10 doesn’t allow any power to the network devices to keep them running even after the machine is shut down by the user, so, the network cards can’t be armed to receive any WOL commands from another system. Wake On Lan or WOL won’t work on a remote computer in a complete shutdown state (S5) if the remote computer is running on Windows 10. WOL is not supported on Windows 10 remote devices which are shut down AC power is a must requirement for the WOL to work properly. The Wake on Lan or WOL doesn’t work properly if the remote computer is running on battery power. ![]() Then, click on “ Apply” and “ OK” to save these modifications.įix 6 – Make sure the AC power is plugged in
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |